April 10, 2005

While I was waiting for the fibreglass to set up a bit I primed my instrument panel. I’m in a bit of a dilemma here with how to make this work with the glovebox on. I masked of the area where the glovebox rivets are, and proceded to paint. Afterwards, I figured it might be better to just drill out the glovebox door mechanism so that I can rivet on the glovebox itself, without having to put the door on. Then put the door on later.sounds like a much better plan. So, tomorrow, this should be dry so I’ll go ahead and rivet the glovebox on. I’ll use Saran wrap over the opening to protect the inside of the glovebox from wet sanding and paint overspray. Hopefully this will work! I’ll wet sand it before I rivet it around the glovebox opening to even out the primer.